| Description: |
This is also referred to by Bernie Bergmann as Part No: 911 NO Heater 5.7" rod
This 911 kit is shipped with the alternator, fan, ring and idler pulley fully assembled.
The shrouds come in 3 different widths to accommodate engines that have been built with stock length rods (5.4") or engines with 5.5"-5.6" rods and 5.7" rod lengths.
If you are not sure as to what rod length you have in your engine, simply measure the distance from the top exhaust stud on one side of the engine to the top exhaust stud on the other side of the engine.
A stock length rod engine should be approximately 20"
An engine with 5.5" or 5.6" rods will measure out at 20.5"
Engines with 5.7" length rods will be 21"
This MADE IN THE USA kit is made to fit VW engines with 5.7" rods & stock type cylinder heads & street eliminator heads.
It comes with all of this:
110 Amp Alternator with Internal Regulator
Heavy Duty Alternator Cable
12 Blade Fan with Serpentine Pulley, balanced
Serpentine Fan Belt
Oil Cooler Block Off Plate and Fuel Pump Block Off Plate
45 degree Brass Fitting for Oil Pressure Sender (not included)
Large Aluminum Ring with 4 Support Posts
Alternator Stand with Oil Filler Tube and Dual Bearing Idler Pulley with Bracket
Crank Serpentine Pulley with Chrome Bolt & Washer
Wide Stainless Steel Straps
Fiberglass Shroud - Paint Grade finish
Electrical diagram for alternator connections & installation instruction sheet
Ground shipping in the contiguous United States, direct from Bernie Bergmann. For shipping to Alaska, Hawaii, Puerto Rico and Virgin Islands, purchase this kit AND additional shipping for $100 as part# 100shipping.
For questions about this kit that is not explained here, feel free to contact Bernie Bergmann at 405-273-7775
Allow 7 days to ship, please. |
