throttle lever activator for hooking up throttle cable to Empi 9/16"
Part number:
43-1018-3
Your cost:
$36.00
Description:
Aluminum throttle lever activator for hooking up throttle cable to 9/16" (flat to flat) hex shaft crossbar linkage.
YOU MAY need cinch bolt part# 99-1221 (10/32 pitch x 3/4" long (shown, but NOT included)
One sold here, shown on the right* in the loose picture.
This is the bar (about 3" long) that hangs off of the cross bar (points at the fuel pump) that the throttle cable connects to (with a barrel nut, NOT included).
In the installed pic, you can see where I clearance off the edges of the hexbar to allow adjustment of the lever without having to remove it from the shaft assembly.
If this fits your shaft a little too loose, you can open the back of the hex opening with a thin saw blade for example, creating a tiny gap. When you tighten the cinch bolt, the gap will close and the activator will then be tight against your hex crossbar.
Dimensions from Empi:
Large serrated hex bar hole to last barrel nut hole, ctr to ctr = 2.500"
Large serrated hex bar hole approx. ID = 5/8"
Small barrel nut hole ID = 5/16"
*For the smaller shaft (7/16"), see part 444.311.08DH
YOU MAY need cinch bolt part# 99-1221 (10/32 pitch x 3/4" long (shown, but NOT included)
One sold here, shown on the right* in the loose picture.
This is the bar (about 3" long) that hangs off of the cross bar (points at the fuel pump) that the throttle cable connects to (with a barrel nut, NOT included).
In the installed pic, you can see where I clearance off the edges of the hexbar to allow adjustment of the lever without having to remove it from the shaft assembly.
If this fits your shaft a little too loose, you can open the back of the hex opening with a thin saw blade for example, creating a tiny gap. When you tighten the cinch bolt, the gap will close and the activator will then be tight against your hex crossbar.
Dimensions from Empi:
Large serrated hex bar hole to last barrel nut hole, ctr to ctr = 2.500"
Large serrated hex bar hole approx. ID = 5/8"
Small barrel nut hole ID = 5/16"
*For the smaller shaft (7/16"), see part 444.311.08DH
Availability:
In Stock
We accept the following forms of payment:
