clearance Mahle cylinders for 10mm head stud use
Part number:
cmc
Description:
if you have a set of 10mm head studs and plan to use them with (new to you) Mahle (and some other brands as well) cylinders, here's what you MIGHT encounter:
the cylinders might not slide all the way down to the block and if they do, the head might not slide down over the studs.
the reason is, the manufacturer left a lot of material at the base right where the stud fits
the cure, is to grind away some material and mark that ground area with a felt pen
now slide that cylinder down over your studs
if it doesn't go all the way down, tap the cylinder down just a tiny bit and then pull it all the way back off
look for any tiny marks in the felt pen area
grind in those areas until the cylinders fit nice and easy
the cylinders might not slide all the way down to the block and if they do, the head might not slide down over the studs.
the reason is, the manufacturer left a lot of material at the base right where the stud fits
the cure, is to grind away some material and mark that ground area with a felt pen
now slide that cylinder down over your studs
if it doesn't go all the way down, tap the cylinder down just a tiny bit and then pull it all the way back off
look for any tiny marks in the felt pen area
grind in those areas until the cylinders fit nice and easy
We accept the following forms of payment:
