build or rebuild your turnkey engine (single carb or FI) type 4 from the rod bearings out
Part number:
rods out single 4
Your cost:
$2,200.00
Description:
To have your VW turnkey engine with a single carb or Fuel injection built by us, from the rod bearings out, you must supply the following:
The exhaust - remove it all Bring a deposit of $1000 $2200 for labor only, with parts, machine work*, and any related shipping being extra.
[/list]
I will tear it down to the rod bearings, replace the rod bearings, inspect & possibly reuse the rods. If the rods need rebuilt, they'll get sent out for: rebushing, end to end balancing & mate balancing & new nuts.
I'll install a new piston & cylinder kit with Total Seal Gapless 2nd rings.
I'll inspect & possibly reuse your heads (they will NOT be cleaned other than a rinse in the solvent tank). If they leak or are cracked you'll get either your heads rebuilt or new heads.
I'll install new pushrod tubes* & seals. I'll clean & blow out the pushrods.
I'll inspect & reinstall your valve train at the correct lash & install the valve covers.
Of course any gaskets encountered in the process will be replaced with new.
The rest of the engine will be reassembled as it was taken apart.
*where applicable
*Machine Work meaning:
- A clean turnkey engine. Pressure wash at a car wash or steam clean the engine before bringing it to be rebuilt.
- Bring the turnkey engine, without:
- The oil in it - drain it all out first
I will tear it down to the rod bearings, replace the rod bearings, inspect & possibly reuse the rods. If the rods need rebuilt, they'll get sent out for: rebushing, end to end balancing & mate balancing & new nuts.
I'll install a new piston & cylinder kit with Total Seal Gapless 2nd rings.
I'll inspect & possibly reuse your heads (they will NOT be cleaned other than a rinse in the solvent tank). If they leak or are cracked you'll get either your heads rebuilt or new heads.
I'll install new pushrod tubes* & seals. I'll clean & blow out the pushrods.
I'll inspect & reinstall your valve train at the correct lash & install the valve covers.
Of course any gaskets encountered in the process will be replaced with new.
The rest of the engine will be reassembled as it was taken apart.
*where applicable
*Machine Work meaning:
- If I or a machinist needs to use any power tool to provide clearancing
- If I or a machinist needs to use any power tool to drill a hole
- If I or a machinist needs to use any power tool to shave a cylinder for stud clearance
- If I or a machinist needs to use any power tool to shave a cylinder for rod clearance
- If I or a machinist needs to use any power tool to smooth away debris or sharp edges left over from manufacture of a part
- If I or a machinist needs to use any power tool to smooth away debris or sharp edges left over from previous machine work
We accept the following forms of payment:
