Bearing Linkage Kit f/ Hex bar linkage conversion Empi
Part number:
44-1127
Your cost:
$69.00
Description:
This kit fits engines using the Doghouse or 36HP Shrouds
Modifying the EMPI Hex Bar linkage kit with Needle Bearings is very, very simple.
Remove the Ball End Bolts from the Hex Bar and replace them with the Modified Bolts in this kit, reusing your two locking nuts.
Remove the stock White Plastic Liner from the Top Metal Carb Plates and install the new Bearing.
Now GREASE the Bearing Holder (to 95% capacity) and slide in your original Tension Springs.
If the Hex Bar is now too long, whatever you need to cut off to shorten it, cut EQUAL amounts from each end.
Reinstall the Hex Bar and original linkage parts and you are done. I suggest Synchronizing the carburetors and linkage again.
Enjoy a whole new driving experience.
Modifying the EMPI Hex Bar linkage kit with Needle Bearings is very, very simple.
Remove the Ball End Bolts from the Hex Bar and replace them with the Modified Bolts in this kit, reusing your two locking nuts.
Remove the stock White Plastic Liner from the Top Metal Carb Plates and install the new Bearing.
Now GREASE the Bearing Holder (to 95% capacity) and slide in your original Tension Springs.
If the Hex Bar is now too long, whatever you need to cut off to shorten it, cut EQUAL amounts from each end.
Reinstall the Hex Bar and original linkage parts and you are done. I suggest Synchronizing the carburetors and linkage again.
Enjoy a whole new driving experience.
Availability:
Ships within 4-7 business days
We accept the following forms of payment:
