rocker stand shim set .030 set of 4 Empi
Part number:
21-2330
Your cost:
$3.70
Description:
rocker stand shim .030 set of 4.
The specs are:
.375" hole
the square is: 1.020" tall x .752" wide
Empi packaged.
This builder has had to open up to 2 packages of these shims to get all 4 that were close to .030 thick so they all matched in thickness.
If you want your rocker shafts sitting parallel to the head on install, you might consider doing the same.
These shims are stamped out, not cut out. As a result of the stamping process, the edge of the shim may 'read' thicker than the shim is on your micrometer. If in question, you should file the edges smooth, then measure.
The specs are:
.375" hole
the square is: 1.020" tall x .752" wide
Empi packaged.
This builder has had to open up to 2 packages of these shims to get all 4 that were close to .030 thick so they all matched in thickness.
If you want your rocker shafts sitting parallel to the head on install, you might consider doing the same.
These shims are stamped out, not cut out. As a result of the stamping process, the edge of the shim may 'read' thicker than the shim is on your micrometer. If in question, you should file the edges smooth, then measure.
Availability:
In Stock
We accept the following forms of payment:
