rocker stand shim set .060 set of 4 Empi
Part number:
21-2360
Your cost:
$3.70
Description:
rocker stand shim .060 set of 4.
The specs are:
.375" hole
the square is: 1.020" tall x .752" wide
Empi packaged.
This builder has had to open up to 2 packages of these shims to get all 4 that were close to .060 thick so they all matched in thickness.
If you want your rocker shafts sitting parallel to the head on install, you might consider doing the same.
These shims are stamped out, not cut out. As a result of the stamping process, the edge of the shim may 'read' thicker than the shim is on your micrometer. If in question, you should file the edges, then measure.
The specs are:
.375" hole
the square is: 1.020" tall x .752" wide
Empi packaged.
This builder has had to open up to 2 packages of these shims to get all 4 that were close to .060 thick so they all matched in thickness.
If you want your rocker shafts sitting parallel to the head on install, you might consider doing the same.
These shims are stamped out, not cut out. As a result of the stamping process, the edge of the shim may 'read' thicker than the shim is on your micrometer. If in question, you should file the edges, then measure.
Availability:
In Stock
We accept the following forms of payment:
